lunes, 11 de febrero de 2013

The respiratory sistem


For that project you will need:
-Clear 2-liter plastic soda bottle.
-Scissors
-Y-tube.
-String .
-Pair of latex gloves.
-Rubber band.
- Straw
Instructions:

    1.   Cut the bottle in a half
    2.  Then you take your y-tubes and you take the straw for put it in the top of the bottle later. Next, in the lower holes you put two gloves



    3.  Now, paste the gloves with scotch tape


   
 4.  Cut all the fingers of the glove




    5.  Put scotch tape in the finger, so that way the air won't pass through the hole made before




    6.  Blow the straw, and if swell is that it's ok. If it not, then review the holes made in the fingers
of the glow for see wih one of them is not well glued




     7.  Put another glove in the lower zone



    8. Cut all the fingers of the glove that it's in the lower zone, exactly alike you did before with the another gloves


    9.  To finish paste the holes that you did cutting the fingers


    10.  To get sure blow again and if it swell it's fine if it doesn't swell, you did something wrong. Likely you didn't paste well the holes made in the instruction 8

Now you have your model of the respiratory sistem

     Notes:
     - The bottle represents the ribcage
     - The two gloves that are inside the bottle represents the lungs
     - The glove that is in the lower zone represents the diaphragm

Problems:
      The biggest problem that I have was cut the finger (the solution I give it in the instructions already) and that my Y-tube was too big, so I advise you to use ones smallers